08 Lancer Gts Stock Amp? - Mitsubishi Forums

08 Lancer Gts Stock Amp? Jump to Latest 36K views 11 replies 12 participants last post by duffmasterfresh Oct 31, 2009 R

http://www.alldatadiy.com/alldata/AFI~V11158024~C40809~R0~OD~N/

NOTE: If the adjustment has been changed by mistake, the idle speed may become too high or the idle speed may drop too low when loads A/C, defogger, etc. are placed on the engine. If this occurs, adjust by the following procedure.

Lancer 2005 Engine Swap | Mitsubishi Forums

Hello. I am trying to figure out my options for swapping the engine in my lancer 2005. The engine is a worn out 4G13. What are my options for swapping the engine with the least amount of modifications. Any help would be highly appreciated.

ENGINE Workshop Manual 4G9 (E-W) - Mitsubishi Forums

GENERAL INFORMATION 4G92 ... *: LANCER for general export and CARISMA for 6B model 11A-0-4 4G9 ENGINE (E-W) - General Information 4G93

Lifting a Lancer? | Mitsubishi Forums

I Am looking for a way to lift my Lancer about an inch or so off the ground. So far all my research online has come up empty but I don't want to give up. One of my buddies put strut spacers in his Subaru to lift it and I haven't been able to find any for a Mitsubishi. If they don't make them...

09 Lancer Turbo Kit | Mitsubishi Forums

09 Lancer Turbo Kit Jump to Latest 40K views 69 replies 24 participants last post by Mitsu_LancerGTS09 Mar 11, 2012 Mitsu_LancerGTS09 Discussion starter

Lancer 2010 loosing power | Mitsubishi Forums

Hi. I need some help, I have a lancer 2010 1.5 and somtimes it is loosing power and the engine check lamp goes on then I open the fuel cap and as soon as...

2011 Mitsubishi Lancer ES. | Mitsubishi Forums

2011 Mitsubishi Lancer ES. Jump to Latest 4.8K views 3 replies 3 participants last post by izerous Aug 15, 2016 D

Poor idling, dies and rough driving. - Mitsubishi Forums

The lancer is a 2004 with 174,000 miles on it. *The mass airflow was replaced. *The idle air control valve was replaced. *New head gasket and valve cover *Replaced spark plugs and only 1 ingition coil *Cleaned EGR valve *Cleaned pvc valve *Vacuum tested with carb cleaner around the engine...

2012 Lancer Gt Front Bumper Fitment - Mitsubishi Forums

Hello, I was wondering if the new 2012 Lancer GT front bumper (Ralliart style) will fit on a 2008+ Lancer bolt on with no modification? Also, what other parts, if needed, will be required for this modification? Thank you!!!!!!